Sale
USE A 2mm Wrench to secure screw
Due to the G20/40 frame variances year to year it is recommended to use the SLR Glock 10mm Floor plate (Link Below)
Some frames will not allow easy mag retention in frame when using magwell. Frame to frame this can vary.
Our Glock 10mm Floor plates solve this issue.
Gen 4 G20/40 Magwell Adapter
For SF Models only
Fits Gen 4 Glock 20 and Glock 40 10mm pistols
Fits Gen 4 Glock 21 and Glock 41 .45ACP Pistols
- 7075 Billet Aluminum
- Includes ultra low-profile billet attachment screw
- Made to fit each gen and model like a glove. No "one size fits all" like many out there
- Will work with 10-round mags (for states with capacity restrictions)
- Will not work with back straps
-Does not work with TT extensions currently unless pin on extension is shortened.
Magwell screw only needs to be finger tight. Do Not Overtighten.
NOTE- install over front lip of grip before pushing rear into place.
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither SLR Rifleworks, LLC nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com
