Gen 5/19 , 19MOS , 23 , 44 (NO HALF MOON CUT) Magwell

Gen 5/19 and 5/19MOS , 5/23 and G5/44 .22 (NO HALF MOON CUT) Magwell 

USE A 2mm Wrench to secure screw

- See Comparision Photo

Left to Right

519 MOS EDC (Narrow profile , flat nose)

519 MOS Competition (Narrow profile , round nose)

519 MOS SHORT  (Standard profile , flat nose)

519 MOS (Standard profile)

----------------------------------

5/19 MOS STD

FOR NO HALF MOON CUT FRAMES ONLY

- 7075 Billet Aluminum

- Black hardcoat anodize

- Includes ultra low-profile billet attachment screw

- Includes relief for Taran Tactical pin

- Will work with 10-round mags (for states with capacity restrictions)

- Will not work with backstraps

   Magwell screw only needs to be finger tight. Do Not Overtighten.

  NOTE- install over front lip of grip before pushing rear into place.

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.

DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither SLR Rifleworks, LLC nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com