SD 9.25" ML - 13.25" OAL

SLR SD  9.25"/13.25" Suppressor Handguard

9.25" base length/13.25" overall length

For AR15 Upper receivers

• 9.25" base length is ideal for 10.0" barrels and any suppressor up to 1.75" OD 
• 13.25" Overall length 
• Barrel Shoulder to end of HG is 4"  This allows shorter K type suppressors and anything longer. (At least 4.5" suppressor length recommended)
• 1.8" Handguard ID
  
• Includes 4 special locking nuts for accessories on suppressor end to mount without interference with suppressor. (Up to 1.7" OD Suppressors)
• 2 Limited Rotation QD's
• No timing of barrel nut required, no shims needed
• Mil-Spec Hardcoat Anodize
• 7075 Barrel nut  included w/Hardcoat Anodize
• Free Floating Design
• Proven Slip fit locking mounting system and universal anti rotation insert
  
• Barrel nut uses standard wrenches or SLR Billet wrench for perfect fit
• Continuous top rail design allows optic mounts to cross receiver/handguard threshold
• 12.5oz with barrel nut and hardware

NOTE: Built Rifle images may show STD or ZRO Anti Rotation system (HG's are the same except for A/R)

NOTE: Make sure any rear end caps on direct threaded cans are very secure before threading on a suppressor.

If rear end cap stays on when can is removed it may be very difficult to remove end cap from inside HG.