SD ZRO 10.5" ML - 14.5" OAL

AR15 SD 10.5"/14.5" Suppressor Handguard (ZRO TYPE)

10.5" base length/ 14.5" overall length

This Handguard uses the ZRO mounting pin

Steel Dowel Pin Precision Interface between HG and Receiver.

Works with SLR Receivers with ZRO locking hole. B15 and B56 uppers are pre drilled for ZRO pin

We now will offer a FREE service to drill any AR15 Upper receiver to receive the ZRO dowel pin.

Send us your stripped receiver AND a return label. We will drill upper and return to you.

• For AR15
• 6061 T6 ALUMINUM
• 10.5" base length is ideal for 11.3"-11.5" barrels and any suppressor up to 1.75" OD 
• 14.5" Overall length 
• Barrel Shoulder to end of HG is 4.0"  This allows shorter K type suppressors and anything longer. (At least 4.5" suppressor length recommended)
• 1.8" Handguard ID
  
• Includes Hardened Nitrided Steel Dowel Pin
  
• Includes 4 special locking nuts for accessories on suppressor end to mount without interference with suppressor. (Up to 1.7" OD Suppressors)
• 2 Limited Rotation QD's
• No timing of barrel nut required, no shims needed
• Mil-Spec Hardcoat Anodize
• 7075 Barrel nut  included w/Hardcoat Anodize
• Free Floating Design
• Proven Slip fit locking mounting system
  
• Barrel nut uses standard wrenches or SLR Billet wrench for perfect fit
• Continuous top rail design allows optic mounts to cross receiver/handguard threshold
• 13.4oz with barrel nut and hardware

NOTE: Built Rifle images may show STD or ZRO Anti Rotation system (HG's are the same except for A/R)

NOTE: Make sure any rear end caps on direct threaded cans are very secure before threading on a suppressor.

If rear end cap stays on when can is removed it may be very difficult to remove end cap from inside HG.