Gen 5/45 , 5/34 , 5/47 , 5/17 (NO HALF MOON CUT) Magwell EDC
These Magwells are extra narrow to fit in the "BOX" for IDPA but with a flat nose virtually no print carry.
1.37" Wide/34.5mm
USE A 2mm Wrench to secure screw
- See Comparision Photo
Left to Right
5 45 (Standard profile)
5 45 SHORT (Standard profile , flat nose)
5 45 Competition (Narrow profle , round nose)
5 45 EDC (Narrow profile , flat nose)
----------------------------------
FOR GEN 5/45 , 5/34 , 5/47, 5/17 NO HALF MOON CUT
- 7075 Billet Aluminum
- Black hardcoat anodize
- Includes ultra low-profile billet attachment screw
- Includes relief for Taran Tactical pin
- Will work with 10-round mags (for states with capacity restrictions)
- Will not work with backstraps
Magwell screw only needs to be finger tight. Do Not Overtighten.
NOTE- install over front lip of grip before pushing rear into place.
DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither SLR Rifleworks, LLC nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com
