Gen 5 G19/23 Magwell - SHORT (WITH HALF MOON CUT)

Write a Review
SKU:
GL-MW-19-G5-S

Options

$99.99
Or

Description

Gen 5 G19 / 23 Magwell Adapter  - SHORT (On left in comparison photo)

USE A 2mm Wrench to secure screw

These Magwells do not have the lip on the very front that catches your pinky.

FOR FRAMES WITH HALF MOON CUT ONLY (SEE PHOTO HMC CUT ON LEFT)

- 7075 Billet Aluminum

- Includes ultra low-profile billet attachment screw

- Made to fit each gen and model like a glove. No "one size fits all" like many out there

- Includes relief for Taran Tactical pin

- Will work with 10-round mags (for states with capacity restrictions)

-Will not work with backstraps

   Magwell screw only needs to be finger tight. Do Not Overtighten.

  NOTE- install over front lip of grip before pushing rear into place.
 

Cerakote option in link below

Cerakote for Small Parts

 
 
 
 

DISCLAIMER: This product is not manufactured, authorized, endorsed, or warranted by GLOCK. GLOCK does not warrant or represent that this product is compatible with GLOCK pistols.

DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither SLR Rifleworks, LLC nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com

  • 5
    Gen 5 G19 Magwell

    Great product and good fit, right out of the box. Low profile and just right for carry!!

  • 5
    Exactly as advertized (no lip)

    The magwell feels *sturdy* and fills the halfmoon without adding a ton of bulk or weight. The screw sticks out a bit but it doesn't dig into the hand at all. $80 is pricey, BUT I haven't found a better one for less.